How long does a voice agent take to start speaking?
Measured in milliseconds, from the moment the caller stops talking to the moment the agent's audio actually starts. That gap is what this board calls TTFAB — time to first audio byte, and it is the silence a real caller sits through on every single turn. Across 5 platforms and 2078 usable turns, the shortest typical wait measured is 1,296 ms (Telnyx); the longest median on the board is 1,740 ms. If you have seen a vendor quote a much smaller number for the same thing, that is expected, and the reason is below — it is a different clock, not a better one.
Two numbers per platform, and they can disagree
TTFAB is reported twice for every platform. A platform can lead one reading without leading the other, so the table below carries both.
| Reading | The question it answers | What it means |
|---|---|---|
| Median (p50) | How long is the pause on a normal turn? | Half of all turns are faster than this. It is the wait a caller gets most of the time, and the number to compare if the calls you care about are ordinary ones. |
| Tail (p95) | How bad is it when it is bad? | One turn in twenty is at least this slow. It matters more than it looks on a phone call: past roughly two seconds of silence a caller assumes the line dropped and starts talking again, which collides with the agent's reply and derails the turn. A platform can win the median and still do this to callers twice a conversation. |
TTFAB data, lowest median first
Every figure read off the call's own audio, pooled over usable turns. Discarded turns are counted, not hidden — a platform that fails to answer is worse than one slightly slower.
| # | Platform | Median TTFAB | p95 | Tail ratio | Usable turns | Discarded |
|---|---|---|---|---|---|---|
| 1 | Telnyx | 1,296 ms | 1,856 ms | 1.43× | 419 / 432 | 13 |
| 2 | ElevenLabs | 1,424 ms | 1,768 ms | 1.24× | 429 / 432 | 3 |
| 3 | Bland AI | 1,520 ms | 2,248 ms | 1.48× | 429 / 432 | 3 |
| 4 | Vapi | 1,558 ms | 2,008 ms | 1.29× | 382 / 432 | 50 |
| 5 | Retell AI | 1,740 ms | 2,259 ms | 1.30× | 419 / 430 | 11 |
Tail ratio is the two readings divided — p95 ÷ median — and it is the one number a vendor cannot usefully publish about itself, because it only means anything when a single instrument produced both figures on the same calls. At 1.2× a platform's bad turns feel close to its normal ones. At 3× a caller regularly waits three times what the median promised. On a phone call that is where the damage is: past roughly two seconds of silence a caller assumes the line dropped and starts talking over the agent, which collides with the reply and derails the turn. So a platform can win the median and still do that to callers twice a conversation — read the tail ratio before the median, not after it.
There is no single fastest voice agent platform — which one wins depends on which pause your callers actually notice. Pick the workflow that matches yours:
- Most of your calls are ordinary back-and-forthTelnyxmedian 1,296 ms
Every turn is a normal question with a normal answer, so what matters is the wait a caller gets most of the time rather than the worst case.
- A caller must never think the line droppedElevenLabsp95 1,768 ms
Long pauses make callers talk over the agent or hang up, and that is a property of the slow turns, not the typical ones. Judge on the tail.
Full ranking, both readings, and the discard counts: the voice agent latency benchmark →
Read off the call's audio, never from a platform's timestamp
A platform measures from where it stands, and the caller is not standing there. We checked that two ways on this bench. A platform's own recording of a call reads roughly 550 ms earlier than our recording of the same call. The latency a platform reports for itself runs roughly 490 ms below what we measure from that call's audio. The two figures agree, and that agreement is the finding: both describe the moment a reply was produced, not the moment a caller heard it. Neither is dishonest — they answer a different question than the one a caller is asking. This board answers the caller's.
1. A caller robot dials the platform's agent over a real phone call and reads a fixed script — a greeting, several scripted questions, and a goodbye — one measured turn each.
2. Both sides of the call are recorded on one clock (a dual-channel recording).
3. Both endpoints are then found in that recording: our speech-end (t1) and the agent's reply start (t2), each by a speech detector (Silero VAD) with an energy refinement and an independent cross-check. No timestamp reported by any platform is used.
4. TTFAB = t2 − t1, per turn. Turns failing quality gates (the two sides talking over each other, detectors disagreeing, no reply) are discarded and the discard counts are published.
Recording-path overhead sits inside every figure here. We have not characterised the current path against a known-delay reference, so we quote no overhead figure and subtract none.
We always call from Plivo, which is not a platform under test, but the leg that answers belongs to whoever ships the number: Telnyx on its own network, Retell's and Bland's Twilio-backed inside their own accounts, Vapi's upstream undisclosed, and ElevenLabs — which sells no numbers — on a Twilio number we bought for it. Twilio was a deliberate choice there: a Telnyx number would have worked, but Telnyx is itself on this board, and one platform's network should not carry another platform's row.
A discarded turn is one we could not time to our own standard: the two sides talked over each other, our two speech detectors disagreed on where speech began, or no reply came. Discards are published per reason and per platform, because the count is sometimes a fact about the platform rather than about us — an agent that starts a reply, stops, and resumes a second later will split our detectors, and that is the agent's behaviour, not our recording's.
Our speech-end is found by a detector, not by matching a known waveform. It carries a few milliseconds of error. Differences smaller than that are not resolvable, and we do not claim them.
Cost/min is measured the same way the latency is: from what actually happened, not from a rate card. After a run we ask each platform's own billing API what every call cost, sum those charges, sum the seconds each platform says it invoiced for, and divide — total cost ÷ total billed minutes, pooled across the run rather than averaged per call, so a long call weighs more than a short one. Two consequences worth knowing. Where a platform bills a minimum, the figure is lower than the cost of a minute of conversation: Telnyx charges 60 seconds for a ~44-second call, so its invoiced $0.0500 sits against $0.0722 per minute actually spent talking, and both are published. And the carrier leg is excluded throughout — that is our cost for dialling, identical for every platform, and folding it in would tax each row for our own plumbing. Anything that qualifies a figure — a free or discounted tier, a unit conversion, an excluded component — travels with it in cost_notes rather than being silently absorbed.
Endpointing — how long a platform waits after you stop talking before it decides you are finished — is pinned to 0.1 s on Telnyx, Vapi and Retell. It is the one setting we do not leave at the default, and the reason is that it is a timer sitting inside the number being measured: a platform that ships a 1.5 s wait posts a slower TTFAB without its stack being any slower, and the board would be comparing configuration choices rather than engineering. Vapi shipped 0.4 s (1.5 s after speech ending without punctuation) and Retell 1000 ms; both now run 0.1 s. Bland and ElevenLabs expose no equivalent fixed-wait knob, so they run whatever they ship and their figures still contain a wait we could not equalise.
Full method, the per-turn latency curve, and the instrument's own limits are on the voice agent latency benchmark.
Voice agent time to first audio byte — common questions
What is time to first byte for a voice agent?
Close, and the difference is worth knowing. Time to first byte (TTFB) is borrowed from HTTP, where it means the first byte of a response leaving a server; applied to a voice stack it usually means the first byte of synthesised audio leaving the platform. Time to first audio (TTFA) is used loosely for much the same thing. TTFAB as measured here starts and ends somewhere else: it starts when the caller stops speaking, not when the platform decides they have, and it ends when the agent's audio is present in the recording of the call, not when the platform emitted it. So it contains the endpointing wait and both network legs, which a server-side first-byte figure does not. Expect it to read higher than a vendor's TTFB for the same call, and expect the gap to be the part of the wait the caller experiences and the server never sees.
How long does a voice agent take to start speaking?
On this benchmark, between roughly 1,296 ms and about two seconds, depending on the platform and on whether you mean a typical turn or a slow one. Telnyx has the shortest measured median at 1,296 ms, with one turn in twenty at 1,856 ms or worse. Those are wall-clock waits from a real phone call, including the network and the phone leg, not a server-side processing time.
Is TTFAB the same as time to first audio (TTFA)?
Nearly, and the difference is where the clock stops. Time to first audio is usually reported as the moment a platform emits audio. TTFAB as measured here is the moment that audio is present in the recording of the call — after the network and the phone leg, at the point a caller could actually hear it. The two answer the same question from opposite ends of the wire, and the gap between them is the part of the wait a server-side figure cannot see.
Why measure in milliseconds rather than seconds?
Because the differences that matter are smaller than a second. The platforms on this board sit within a few hundred milliseconds of each other at the median, and a caller notices a 300 ms difference in a way that a figure rounded to '1 second vs 2 seconds' would hide entirely. The tail is the exception — there the gaps are large enough to read in whole seconds, which is rather the point of publishing both.
What is a voice agent's latency budget made of?
Endpointing, speech recognition, the model's turn, speech synthesis, and the network and telephony legs at both ends. This benchmark deliberately does not split the total into those components: it measures from outside the platform, where the only two observable events are the caller going quiet and the agent starting to speak. A per-component breakdown can only come from the platform's own internal instrumentation, which is the source this board exists not to depend on.
What is TTFAB (Time To First Audio Byte)?
Time from the moment the caller stops speaking to the moment the agent's audio starts — the silence a real caller sits through on every turn. Measured from a saved recording of the actual phone call, not from any API timestamp. Lower is better. Also written time to first audio byte, and closely related to what other boards call time to first byte (TTFB) or time to first audio (TTFA).
Is TTFAB the same as time to first byte (TTFB) or time to first audio (TTFA)?
Close, and the difference is worth knowing. Time to first byte (TTFB) is borrowed from HTTP, where it means the first byte of a response leaving a server; applied to a voice stack it usually means the first byte of synthesised audio leaving the platform. Time to first audio (TTFA) is used loosely for much the same thing. TTFAB as measured here starts and ends somewhere else: it starts when the caller stops speaking, not when the platform decides they have, and it ends when the agent's audio is present in the recording of the call, not when the platform emitted it. So it contains the endpointing wait and both network legs, which a server-side first-byte figure does not. Expect it to read higher than a vendor's TTFB for the same call, and expect the gap to be the part of the wait the caller experiences and the server never sees.
How is this different from vendor-reported latency?
A platform measures from where it stands, and the caller is not standing there. We checked that two ways on this bench. A platform's own recording of a call reads roughly 550 ms earlier than our recording of the same call. The latency a platform reports for itself runs roughly 490 ms below what we measure from that call's audio. The two figures agree, and that agreement is the finding: both describe the moment a reply was produced, not the moment a caller heard it. Neither is dishonest — they answer a different question than the one a caller is asking. This board answers the caller's.
How is the latency actually measured?
A caller robot dials the platform's agent over a real phone call and reads a fixed script — a greeting, several scripted questions, and a goodbye — one measured turn each. Both sides of the call are recorded on one clock (a dual-channel recording). Both endpoints are then found in that recording: our speech-end (t1) and the agent's reply start (t2), each by a speech detector (Silero VAD) with an energy refinement and an independent cross-check. No timestamp reported by any platform is used. TTFAB = t2 − t1, per turn. Turns failing quality gates (the two sides talking over each other, detectors disagreeing, no reply) are discarded and the discard counts are published.
Why not pin the same model, speech recognition and voice on every platform?
The stack is not pinned. Each agent runs the model, speech recognition and voice the platform gives a new signup, and we record what it chose. Endpointing is the single exception — it is a timer inside the number we report, so where a platform exposes it we set it to 0.1 s. That one override is stated in full below. Pinning a stack measures a platform you would have to configure to match, not the one you would buy — and it excludes the vertically integrated platforms outright, since you cannot drop a third-party speech recogniser into a platform that owns its own.
What does this benchmark NOT measure?
Not measured: answer quality, voice quality, platform features, and published pricing plans — this board measures response latency, with the cost each platform actually invoiced for the same run reported beside it. Nor is it every platform. LiveKit Agents and Pipecat are frameworks you host yourself, so what a benchmark would time there is somebody's deployment rather than a product. The raw speech-to-speech APIs — OpenAI's Realtime API, Gemini Live — answer a socket, not a phone, and would need a telephony layer built around them first, which would then be inside the measurement. Twilio's own agent product simply has not been dialled yet. Until any of them is measured on the same script over the same carrier, this board has no number for it, and neither does anyone quoting one. Treat those as vendor claims until measured.